NEWMAR POWER Newmar 12 12 35I DC Converter [12 12 35I]

Based on 0 reviews. - Write a review

$96.59

Qty

Add to Cart

Buy Now Question

Add to Wish List

Description

12-12-35I DC Converter

This isolated series provides voltage conversion as well as input/output isolation, allowing the use of negative ground gear in positive or floating ground battery systems, or vice versa.

Using an isolated converter as a voltage stabilizer on 12- or 24-volt systems can solve conducted noise and interference problems on sensitive DC-powered communication, navigation systems, and DC microprocessor-based devices.

Features:

Wide range of input voltage

Precise output voltage regulation

Reverse polarity

Input fuse/output fuse

Total input/output isolation, pos. or neg. ground

Current-limiting, short-circuit-proof output

Automatic resetting of the thermal shutdown

High/low input voltage shutdown

Polyurethane conformal coating on PC board

Power ON light

Rugged case designed for high-vibration applications

Specifications:

Input Voltage: 10-16

Max Input Amps: 56

Output Voltage: 13.6

Output Amps (Intermittent): 35

Output Amps (Continuous): 20

Case Size (H x W x D): 6 x 6.8 x 16.5 inches (15.2 x 17.3 x 41.9 centimeters)

Weight: 12 lb. (5.5 kg)

Output: 13.6 VDC (internally adjustable 12.6 -14.5) or 24.5 VDC (or specify)

Ripple: 150 mV P-P maximum

Regulation: 1% Line/Load

Duty Cycle Ratings: Intermittent – 20 minutes max on time, 20% duty. current limit set at approx. 105% of the intermittent rating. Continuous – 24 hours, 100% duty

Idle Current: Less than 100 mA (including power “ON” light )

Operating Temp: 0-50 degrees C, Derate Linearly From 100% @ 40 degrees C To 50% @ 50 degrees C. Thermal shutdown @ 70 degrees C Case Temperature

Switching Frequency: 40 kHz

Efficiency: 85% – Typical

Isolation – Output/Chassis; Input/chassis: 250 VDC

Mechanical Specifications:

Anodized aluminum heat sink case

Front panel terminal block

Heavy-duty mounting flange

conformal-coated PC board

Options:

Operation as battery charger or parallel redundant operation* – derate to continuous duty rating (contact factory)

Extreme vibration mounting kit. (Information below)

Option: Extreme Vibration Mounting Kit

The Extreme Vibration Mounting Kit is available to protect NEWMAR power converters from the extreme stresses of shock and vibration when mounted on high-vibration vehicles.

The kit replaces the standard vibration kit provided with the unit and fits into the unit’s mounting flange to act as a ‘super shock absorber’ for electronics in high-vibration applications. It is available to fit all NEWMAR units from 2 to 70 lbs. Specify Kit L for units that weigh 2 -15 lbs. and Kit H for units that weigh 16 – 70 lbs.

This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.