Polk Audio PA D4000.4 PAD Series 4 Channel Amplifier 400W [PAD4000.4]

Based on 0 reviews. - Write a review

$88.00

Qty

Add to Cart

Buy Now Question

Add to Wish List

Description

PA D4000.4 PAD Series 4-Channel Amplifier - 400W

When install space is at a premium, but your sound system demands plenty of power to realize its full potential, Polk Audio’s new super-efficient D Series amplifiers are a very cool solution.

Polk's PA D4000.4 4-channel amplifier may be small, but it can power your front and rear speakers with up to 125 watts RMS each. Or, you can switch this little beast over to 2-channel mode to drive a couple subwoofers with up to 200 watts RMS each. However you use it, this amplifier will fit in almost any location.

Separate high- and low-pass filters on the front and rear channels allow this versatile amp to run a variety of speaker systems, like bi-amped mid-bass and tweeter components, or two front speakers and a sub.

Features:

Super-Efficient Class D Bridgeable Design - Runs cooler than conventional amps.

High-Speed MOSFET Switching power supply.

Front and rear level controls.

Protection - thermal, DC offset, reverse polarity and short circuit.

Nickel-plated wire terminals and RCA connectors.

Stainless steel hardware.

Technical Specifications:

Number of Channels - 4

Frequency Response - 20Hz - 20KHz

2 Ohm RMS Power (14.4V) Per Channel - 4 x 200W

4 Ohm RMS Power (14.4V) Per Channel - 4 x 125W

4 Ohm RMS Power Bridge (14.4V) Channel - 2 x 400W

Signal-to-Noise Ratio - >105dB

Product Dimensions (with panels) (H x W x D) -1.81'' x 10.94'' x 6.75''

*Sold as an Individual

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to .