NEWMAR POWER Newmar 12 12 3i Power Stabilizer [12 12 3I]

Based on 0 reviews. - Write a review

$98.00

Qty

Add to Cart

Buy Now Question

Add to Wish List

Description

12-12-3i Power Stabilizer

Feed sensitive electronics with proper voltage, regardless of the battery condition. This stabilizing converter provides continuous, precisely regulated output over the entire range of a battery’s usable voltage. This prevents subjecting loads to fluctuating input voltage, which can cause shutdown, diminish performance, and possibly damage sensitive circuitry.

This converter provides total input/output isolation, virtually eliminating conducted line noise and permitting the connection of negative ground gear to positive or floating ground systems, or vice versa. It can be modified for use as a battery charger, allowing them to maintain a battery at a great distance from the primary voltage source, providing reserve power if the main source fails. The rugged anodized aluminum case is ideal for marine applications.

Application Benefits Include:

Operate electronics at optimal input voltage, even from nearly drained batteries

Boost voltage to compensate for voltage drops in long wire runs from batteries

Eliminate voltage drops during momentary high current drain from batteries, as during engine start

Eliminate voltage fluctuation from charge sources

Eliminate voltage overshoot due to sudden removal of high current load

Specifications:

Input Voltage: 10-16

Input Amps: 4

Output Voltage: 13.6

Output Amps (Intermittent): 3

Output Amps (Continuous): 3

Case Size (H x W x D): 3.5 x 3.5 x 1.75 inches (8.9 x 8.9 x 4.5 centimeters)

Weight: 1 lb. (.45 kg)

Output: 12 or 24V, nominal, see matrix

Ripple: 150 mV P-P maximum

Regulation: 1% Line/Load

Duty Cycle Ratings:

Intermittent: 20 minutes max on time, 20% duty. Current limit is set at approx. 105% of intermittent rating.

Continuous: 24 hours, 100% duty

Idle Current: Less than 100 mA (including power “ON” light )

Operating Temp: 0-50 degrees C, Derate Linearly From 100% @ 40 degrees C To 50% @ 50 degrees C. Thermal shutdown @ 70 degrees C Case Temperature.

Switching Frequency: 40 kHz.

Efficiency: 85% – Typical.

Isolation – Output/Chassis; Input/chassis: 250 VDC

Mechanical Specifications:

Anodized aluminum heat sink case

Front panel terminal block

Heavy-duty mounting flange

Conformal-coated PC board

Options/Factory Modifications:

Operation as a battery charger (contact factory)

Parallel/redundant operation (contact factory)

High-vibration mounting kit

Non-standard output voltage (contact factory)

Option: Extreme Vibration Mounting Kit

The Extreme Vibration Mounting Kit is available to protect NEWMAR power converters from the extreme stresses of shock and vibration when mounted on high-vibration vehicles.

The kit (pictured here) replaces the standard vibration kit provided with the unit and fits into the unit’s mounting flange to act as a “super shock absorber” for electronics in high-vibration applications. It is available to fit all NEWMAR units from 2 to 70 lbs. Specify KIT–L for units that weigh 2–15 lbs. and Kit–H for units that weigh 16-70 lbs.

This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.